Milling weekend

I bet the air was blue when it happened

I bet the air was blue when it happened

The arm didn’t turn the air blue. When things hurt that much I go very quite. If I’m still swearing, I’m probably alright.
the engine yes there was a tint of blue, but you couldn’t hear it over the noise     .

for those who are FB friends you’ll be able to see what engine is required. I’ve just shared Bobs post.

Just so you get an idea how big a bang the engine made. This used to be Conrads

   

Con rods? Shattered,
I've shared Bob's FB post, just in case anyone has one lying around.

Con rods? Shattered,
I've shared Bob's FB post, just in case anyone has one lying around.

Thank you Veggie     .

I've looked at Bob's pic but sorry, no one to share it with P is incredibly sympathetic.

Everyone it’s finger crossing time again! 
3dr time lucky, we might of found an engine. First 1 was all ready to send videos of it running. 2 weeks later we noticed it’d been sold. A week after that he bothered to tell Bob he’d sold it. Second one. I was dealing with its been dragging on for about 6 weeks. He did say he was in no rush to sell . He got to the stage where he was going to take the engine off the welder. And get his dad to bring it up to Scotland as he was coming up and we could meet him. Then suddenly nothing! Infuriating is an understatement   . Anyway I found engine potential number 3 this morning. Letting Bob sort this one again. But the seller replied to his question already. Still not holding my breath because so did the other two! But if this one messes use about it’s ok because unfortunately for him he’s not to far from Cardiff     we’ll just threaten to send veggie round to have a word   .

I'm ready and raring to go.
Hope this one works out OK without needing me!

Thanks veggie   . Knew I could count on you     .

All available fingers crossed for you.